Fencing Contractors in Herne Bay

Start with privacy, access and the boundary.

A new fence can screen a seating area, define the garden or replace an ageing boundary. Consider the view from the places you sit, gate access and any changes in level. Confirm the boundary line and permission for the proposed work before setting out.

For a Herne Bay garden with an exposed boundary, show where the existing fence has leaned or failed. Height, openness and support details need to suit the particular site; a coastal postcode alone does not establish the right specification.

Photograph the access route as well as the fence. Narrow passages, planted borders and paving that must remain can affect material handling and removal of old posts.

Choose the construction as well as the style.

Closeboard commonly uses overlapping feather edge boards. Site-built fencing can be arranged around the boundary, while ready-made panels provide complete sections between posts. Boards, rails, posts and fixings should be considered together.

Slatted fencing provides a different balance of openness and screening. Gaps, orientation and the viewing angle affect privacy. Discuss the sightline from the patio and neighbouring gardens before choosing by appearance alone.

A solid, taller fence places different demands on supports from a more open design. Agree a complete construction suited to the ground and exposure rather than treating the panel as the whole installation.

Posts, gravel boards and sloping ground.

Existing posts can only be retained if their condition, stability and spacing suit the replacement. Timber and concrete supports differ in appearance and compatibility with the fence system. Ask the quote to identify what will stay and which supports need replacement.

Gravel boards can separate the main timber fencing from soil where the detail suits the construction. Include them when agreeing the overall height.

On a slope, discuss whether the fence follows the ground or steps between sections. Check gaps at the base, especially where you need to contain pets, and allow for the appearance from both sides.

Repair one section or replace the run?

A damaged panel may be replaceable while sound neighbouring sections remain. A rotten post base or unstable support needs attention as well as the visible boards. Repeated failures along the boundary may justify a wider replacement.

For storm damage, send a view of the whole run and close photographs of the posts, rails and fixings. Keep clear of unstable sections. We can discuss what needs checking before deciding whether a targeted repair is suitable.

What does fencing installation cost in Herne Bay?

Length, height, construction, posts, gravel boards, corners and gates affect the total. Removing old fencing, extracting supports, disposal, difficult ground and restricted access also change the work involved.

Compare complete quotations for the same specification. Check removal and disposal, posts and supports, panels or boards, rails, fixings and finishing. Confirm VAT treatment, exclusions and any provisional work.

A supply-only panel price or a fencer’s day rate does not establish the price of your completed boundary. Send the approximate length, preferred height and style, along with photographs of the fence and access route.

Fence height and planning requirements.

In England, the usual planning height limits are 1 metre beside a highway used by vehicles, including its footpath, and 2 metres elsewhere, measured from ground level. Other conditions apply, including restrictions affecting listed properties, planning conditions and Article 4 directions.

For an existing fence above those limits, the guidance allows some work without increasing its height, subject to the other conditions. Conservation areas can also affect removal. Include trellis and gravel boards when discussing total height.

Read the Planning Portal fencing guidance and confirm property-specific requirements with Canterbury City Council before starting work.

Agree the installation and handover.

1. Confirm the line and access. Identify the boundary, gates, retained features and the route for materials.
2. Specify the fence. Agree height, construction, supports and details for slopes.
3. Confirm preparation. Set out removal, disposal and any additional ground work.
4. Install and finish. Fit the agreed supports and fencing, then check alignment and fixings.
5. Discuss care. Follow the timber and treatment guidance and confirm any applicable written warranty terms.

Questions about fencing in Herne Bay

Plan the boundary alongside your garden.

Explore our Herne Bay landscaping services or fencing services across Kent. If you have a larger site or a particular commercial boundary requirement, send the details so we can confirm whether the work is suitable.